Following on from week 1 and week 2, we will be continuing our way through Oomlout’s Arduino Guide, at this point however we hit a snag with using iCircuit. Annoyingly iCircuit is unable to deal with arrays. An array is a cunning way of holding multiple variables inside a single […]
Arduino
28 posts
Most of the stuff you will need to do the electronic projects I do on this site can be got by going to Amazon (I have affiliate links), I know I have mentioned the Oomlout Starter Kit for Arduino, However I fear that this is discontinued 🙁 The Oomlout Starter […]
A fair while ago Swindon Makerspace started a group project called LogoBot, a cheap, expendable and extendable easy to build robot for playing with. Even longer ago I bought a MiroBot from kick-starter, it had lived in a box, and parts of it had got damaged. Tamarisk showed me and […]
I have started putting these on Github so you can also follow along. In Weeks 2, and 3 we were driving LEDs directly from the Arduino, While the Arduino can drive a LED directly from a pin, if you want to power something that draws more power like a motor, […]
Following on from last week where we drove a motor in one direction with the help of a simple amplifier, this week we are going to have a go at driving a servo. Those of you who read older posts in my blog will know I have done this before […]
I picked up a 37 in 1 box sensor kit from china, it includes basic components and sensors, and is compatible with Arduino and Raspberry Pi The Package Included (their description): Small passive buzzer module KY-006 2-color LED module KY-011 Hit sensor module KY-031 Vibration switch module KY-002 Photo resistor […]
This week we will be having a play with a 74HC595, the Data sheet lists it as an 8-bit serial-in, serial or parallel-out shift register with output latches; 3-state.” In other words, you can use it to control 8 outputs at a time while only taking up a few pins […]
Using a LED and a 560 Ω in most breadboard projects means that you end up with four pins connected for two components, soldering them up like this makes them much easer to handle.
I found the ‘Picktor’ Pick and Place head for retrofitting on a 3D printer on Thingiverse (GitHub) As designed it uses a Nema 17 stepper motor, however I suspect that will be too big for my design. I got 3 x Nema 14 stepper motors from an old RepRap Huxley, […]
Like the bearing size code, resister values for LEDs is something that I keep needing to work out, or just go back to my nominal somewhere between 200 Ω and 1 kΩ rule of thumb. While I could work it out every time I need it using and then chose […]
I have spoken to Pycom support about the problems I was having updating the expansion board, and it turns out its a known issue with Mac OS 10.15 due to the security settings in the new version of Mac OS. However the expansion board should have come from the retailer […]
At work, I am trying to make some automated test equipment, (I also have some personal test equipment to automate as well). At work I use MS Windows 10 for my laptop, home I use macOS, and for embedded test equipment I am planning on using Raspberry Pi and Pi […]