#Makevember Post 02 – K9’s Back
Today’s Makevember There seems to be very little consensus on the arangement of the colours of the buttons on the
Today’s Makevember There seems to be very little consensus on the arangement of the colours of the buttons on the
Following on from my previous Makevember posts… This is another virtual post, I built the Wind Turbine Hub as designed
Following on from my Makevember post yesterday, where I tried to make turbine blades, and Failed… I fed 6050 from
I have been a bit lax on my Makevember posts; these were just quick prints I lobbed on the 3D
Another boat: I was trying to dial in a 3D printer, the blobs on the hull seem to be caused
I have been back in Fusion 360 designing parts for my wind turbine: These are parts of the hub, they
After my previous attempts at cadding up air foils, that can be found here and here for #Makevember, I came