Following on from my previous Makevember posts… This is another virtual post, I built the Wind Turbine Hub as designed by Daniel Davis, one of the changes I would like to make, is the methord of making the blades. It…
Following on from my Makevember post yesterday, where I tried to make turbine blades, and Failed… I fed 6050 from SG6050 into Fusion 360 and this is what it gave me: SG6050 profile To check it wasnt it that was…
After my previous attempts at cadding up air foils, that can be found here and here for #Makevember, I came across QBlade; According to Wikipedia: QBlade is an open source wind turbine calculation software, distributed under the GNU General Public…
I have been back in Fusion 360 designing parts for my wind turbine: These are parts of the hub, they are the bearings 3D printed to be the size of F 6902-2RS (15x28x7 mm) bearings that are commercially available, the…