Programming an ATtiny 1614 using UPDI
The ATtiny 1614 is an 8-Bit microcontroller available in a SOIC-16 form factor. It has 13 available GPIO pins (Not […]
Maker
KiCad Traces Net classes
I have done the following work on Net classes in KiCad, which is derived from what I wrote about IPC
UART TX/RX Swapping made simple
When designing boards, one of the things I spend a lot of time checking is if my UART transmit (TX)
Programming an Arduino from the command line
As part of my K9 and ROV projects, I am using at least one Arduino to control components such as
The Internals of Doctor Who’s K9
Ian Hughes’ 3D-printed files for K9 also include files to create internal components that fit under the side featuring the
K9 Button Panel… Which layout?
Bob Clough managed to get our Prusa 3D printer working again, so I am back to printing out parts of
#Makevember Post 02 – K9’s Back
Today’s Makevember There seems to be very little consensus on the arangement of the colours of the buttons on the
#Makevember Post 03 – Turbine Blades
Following on from my previous Makevember posts… This is another virtual post, I built the Wind Turbine Hub as designed
#Makevember Post 04 – Turbine Blades – Attempt number two
Following on from my Makevember post yesterday, where I tried to make turbine blades, and Failed… I fed 6050 from
#Makevember Post 06 – K9’s Back!
I missed a Makevember post yesterday, and the one for today is going to be quite virtual again… Last time
#Makevember Post 17 – Random 3D printed parts
I have been a bit lax on my Makevember posts; these were just quick prints I lobbed on the 3D
QBlade for #Makevember
After my previous attempts at cadding up air foils, that can be found here and here for #Makevember, I came
#Makevember Post 25 – Random 3D printed parts
I have been back in Fusion 360 designing parts for my wind turbine: These are parts of the hub, they
Alternative Wind Turbine designs…
As in my Q-Blade Post 1. I made reference to both HAWT (Horizontal Axis Wind Turbine) and VAWT (Vertical Axis
Re-bulbing K-9’s back buttons
A while ago I picked up these buttons for my Dr Who’s K-9 robot from AliExpress, Hobby Components have similar