Reducing Ripple on DC lines
After AC Rectification, the next step is Reducing the Ripple on the DC supply line as much as possible.
Alternating Current Rectification
AC (Alternating Current) is used for the transmission of mains voltage, one of its main advantages for use as a method of transmission over DC (Direct Current) is that a change of voltage between High Voltage, Low Voltage, and SELV…
EV Connectors for BEVs, PHEVs and EVSEs
For the Charging Two EVs on One EVSE project, I will need a Vehicle Inlet ‘Male’ type EV charging connector for the upstream supply from the existing EVSE. And two EVSE ‘Female’ type EV connectors to allow for connection to…
Charging Two EVs on One EVSE
Like an increasing number of people, we have one home EV charger but have two EVs. My 2015 Nissan Leaf has a range of about 60 miles, which is perfect for daily school runs, and trips to the office. However,…
#Makevember Post 17 – Random 3D printed parts
I have been a bit lax on my Makevember posts; these were just quick prints I lobbed on the 3D Printer: bathtub boat (visual benchy) Duplo train joint The Duplo Train Joints are for MiniBoyGeek, the other part will appear…
#Makevember Post 06 – K9’s Back!
I missed a Makevember post yesterday, and the one for today is going to be quite virtual again… Last time I did a post on K-9’s Back it was to work out how to read the buttons, and to do…
#Makevember Post 04 – Turbine Blades – Attempt number two
Following on from my Makevember post yesterday, where I tried to make turbine blades, and Failed… I fed 6050 from SG6050 into Fusion 360 and this is what it gave me: SG6050 profile To check it wasnt it that was…
#Makevember Post 03 – Turbine Blades
Following on from my previous Makevember posts… This is another virtual post, I built the Wind Turbine Hub as designed by Daniel Davis, one of the changes I would like to make, is the methord of making the blades. It…
#Makevember Post 02 – K9’s Back
Today’s Makevember There seems to be very little consensus on the arangement of the colours of the buttons on the back of K-9, K9 has a 4 x 3 array of buttons on his back, I am using this image…
Alternative Wind Turbine designs…
As in my Q-Blade Post 1. I made reference to both HAWT (Horizontal Axis Wind Turbine) and VAWT (Vertical Axis Wind Turbines), A standard VAWT design has been covered by the Ultimaker Blog: There are several other designs that are…
#Makevember Post 25 – Random 3D printed parts
I have been back in Fusion 360 designing parts for my wind turbine: These are parts of the hub, they are the bearings 3D printed to be the size of F 6902-2RS (15x28x7 mm) bearings that are commercially available, the…
#Makevember Post 24 – Random 3D printed parts
Another boat: I was trying to dial in a 3D printer, the blobs on the hull seem to be caused by buffer under-runs from the Raspberry Pi. In the last Makevember post, there were some strange shaped Duplo links, here…